Teradek User Guide

Data Radio Introduction

Updated on

Bolt 7 has a dedicated data radio operating between 860 and 920 MHz (depending on the region) that runs alongside the 5/6GHz zero-delay video link. The data radio can send camera control, shading, telemetry, and color management data on its own channel, separate from video. Besides plugging a USB or Ethernet cable into Bolt 7, no additional equipment is required for the wireless data bridge.

By default, Bolt 7 also uses the data radio for wireless pairing. The pairing process works like joining a Wi-Fi network: the TX acts as an access point, and the RX scans for it and connects without interrupting other video links. You can pair a transmitter without touching it, for example when it's mounted on a gimbal or a crane. Together with wired pairing, wireless pairing makes setup faster and easier, both in prep and on set.

The data radio has three modes. Choose the mode that fits your application:

  • Client mode extends an existing wired network across the wireless link. In Client mode, Bolt 7 doesn't assign IP addresses and passes all traffic transparently across the data link.
  • Standalone mode turns the Bolt system into its own private network, with no external router needed. Cameras connected to the TX and computers or monitors connected to the RX join Bolt 7's network.
  • USB Serial mode bridges a USB device at one end of the link to a computer or controller at the other end. It works like a wireless USB extension cable for supported cameras.

The following sections describe each mode and how to set it up.

Previous Articles Troubleshooting
Next Articles ARRI Camera Control
Still Need Help? Contact Us