Teradek User Guide

Troubleshooting

Updated on

Use the Troubleshooting menu to run an antenna test or access the Bolt 7 guide for setup instructions and troubleshooting information.

Run Antenna Test (RX)

Run the Antenna Test to check antenna performance on the Bolt 7 transmitter and receiver. Before starting, securely attach all antennas and establish a stable link between the units.

Run an Antenna Test

  1. Attach all antennas to the transmitter and receiver, and check that each connection is secure.
  2. Power on both units and confirm that they are paired.
  3. Place the transmitter and receiver at least 5 feet apart and allow them to establish a stable link.
  4. Disable Broadcast Mode before starting the test.
  5. On the receiver, navigate to Troubleshooting > Run Antenna Test and follow the on-screen prompts.
  6. Wait for the test to finish, then review the results. If an error appears, use the descriptions below to identify the issue.

Status and Error Messages

Test Status

StatusDescription
Pass
The antenna test passed
Not Started
The test has not started.
In Progress
The test is running. Wait for it to finish.
Error
An error prevented the test from starting or completing. Review the accompanying error message.
Fail
The test reported a failure. Review any available results and check the antenna connections.
Unknown
The device cannot identify the test status.

Error Messages

MessageDescription/Action
No ErrorConfirm that the transmitter and receiver have a stable connection, then run the test again.
No Stable LinkConfirm that the transmitter and receiver have a stable connection, then run the test again.
PIN Too LowPower input is too low. Check the power connections and use a compatible power supply or fully charged battery, then rerun the test.
Broadcast ModeDisable Broadcast Mode, allow the units to establish a stable link, then run the test again.
Link DroppedThe connection between the units dropped during the test. Restore the link and run the test again.
TX General ErrorThe transmitter reported an error. Run the test again. Contact Teradek Support if the error persists.
RX General ErrorThe receiver reported an error. Run the test again. Contact Teradek Support if the error persists.
TimeoutThe test did not complete within the allowed time. Check the connection and run the test again.
Already StartedA test has already started. Wait for it to finish before starting another test.

Bolt 7 Guide

Select Bolt 7 Guide to display a QR code that links to the full online user guide. Scan the code with your phone to access setup and operating instructions, including pairing, range tuning, SDI routing, troubleshooting and support information.

Previous Articles System Settings
Next Articles Data Radio Introduction
Still Need Help? Contact Us