The Data Settings let you configure Bolt 7’s dedicated data radio to link devices connected through Ethernet or USB-C. These settings include network modes, receiver connection types, USB forwarding, and advanced data radio options, along with connection status and IP address information.
Table of Contents
Data/Wireless Status
View the current status of the Bolt 7 data connection, including the network name, wireless signal strength, and network mode. This screen also shows passthrough and tethering status, the Link IP address, wired Ethernet connection status and IP address, and USB connection status. Scroll to view all available information.
Net Mode
Bolt 7 supports multiple network modes for different applications.
- Standalone (TX only): use this when using Bolt 7 to bridge data between two devices, with no additional network equipment
- Client: This mode is used when using Bolt 7 with other network equipment, or when a camera/control device is acting as a network DHCP server
- Configuration: Used for configuring individual Bolt 7 devices via a direct connection to a computer
- USB Serial: For connecting cameras that operate as a USB serial device, i.e. RED KOMODO via its EXT port.
For more information about how to configure specific cameras for use with Bolt 7's data radio, see the camera control articles:
Configuration
Use Configuration mode to Bolt 7 to a computer, either to access the built in web UI or configure/upgrade the device using Bolt Manager. Ethernet and USB-C connections remain local to that unit, so connected devices do not share network traffic with devices on other units across the HaLow link.
The transmitter and receiver continue to communicate over HaLow for functions such as pairing. Configuration is the default mode on both units.
Standalone (TX)
Use Standalone mode to create a shared data network without a router or another DHCP server. The transmitter assigns IP addresses to connected devices that request them through DHCP.
Set the transmitter to Standalone and the receiver to Client to connect devices on both ends of the HaLow link. The transmitter assigns addresses from a range beginning with 10.x.y, which varies by its serial number.
Client
Use Client mode to connect devices on the transmitter and receiver to a shared HaLow network. In client mode, a Bolt 7 TX in Standalone mode or an existing router or DHCP server will assign IP addresses. Client mode can also be used if you have configured the camera and controller (e.g. a SmallHD monitor) with static IP addresses.
Select Client on each unit that will join the network. If a phone provides the network connection, select USB iOS or USB Android under Net Type on the receiver.
Net Type (RX Only)
Choose how the receiver connects to the network while in Client mode.
- Ethernet Connect to a network through the Ethernet port. Connected devices obtain IP addresses from a Standalone transmitter or an existing DHCP server.
- USB iOS Connect a tethered iPhone through the USB-C port. The receiver obtains an address from the iPhone and assigns addresses to connected devices within the iPhones network range.
- USB Android Connect a tethered Android phone through the USB-C port. The phone assigns IP addresses to connected devices.
USB Serial
Use USB Serial mode to forward a USB device connected to the transmitter across the HaLow link to the receiver. Select this mode on both units: the transmitter sends the USB connection, and the receiver receives it.
In this mode, the Ethernet and USB-C ports no longer share network traffic across HaLow. Use USB Serial when your setup requires USB device forwarding instead of a shared Ethernet or USB-C network.



