Power your Bolt 7 transmitter and receiver with an external DC power source or compatible batteries using optional battery cradles. Check the power requirements, then follow the instructions below to install battery cradles, connect your video equipment, and power on your devices.
2-Pin Power Connector
Bolt 7 devices use a locking 2-pin power connector similar to the 0B 302 series LEMO connector.
* Pin 1 is closest to the red dot on the connector.
Input Voltage: 6-28V DC
Nominal Power Consumption: 20W (TX) and 18W (RX)
Custom/3rd Party Cables
- Test the power cable polarity with ONLY the power cable connected to Bolt. Do not connect video cables.
- Check the power cable for shorts and proper grounding.
12G-SDI Input/Output Cables
Bolt 7 units require the use of 12G-SDI cables to reliably transport 12G video signals, and they are included as a standard item. Ensure that your cables are rated for compatibility with your camera's output.
CAUTION:
Using a reverse polarity or improperly−constructed power cable can damage the product and is not covered under warranty. To prevent the inputs from being damaged, best practice is to plug in the power cable first, THEN connect the video cable from the camera before powering on the TX unit.
Battery Cradle Installation
- Remove the 2.5 mm screws to release the bottom mounting block from the Bolt TX and/or RX.
- Slide on the battery cradle and secure it to the bottom of the device using the 2.5 mm screws.
- Secure the top of the battery cradle to the Bolt chassis with the additional 2.5 mm screws
Power On
- Connect power to the Bolt 7 transmitter and receiver with the included A/C adapter, or if both devices are equipped with battery cradles, attach a compatible battery (Gold or V-mount).
- Connect the output from your video source to either the SDI or HDMI input on the Bolt transmitter.
- Connect either the SDI or HDMI output from the Bolt 7 receiver to the video input on your monitor. NOTE: If you mount the receiver upright on a stand above the monitor, use a right-angle SDI adapter to relieve strain from the cable's weight and avoid damaging the SDI output’s internal connectors.
- Press and hold the Power button to power on the unit.

