Teradek User Guide

Unintentional Radio Interferance

Updated

FCC COMPLIANCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•    Reorient or relocate the receiving antenna.

•    Increase the separation between the equipment and the receiver.

•    Connect the equipment into an outlet on a circuit different from that to which the receiver is 

      connected.

•    Consult the dealer or an experienced radio or television technician for help


This equipment complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 

1.  This device may not cause harmful interference, and 

2.  This device must accept any interference received, including interference that may cause 

     undesired operation.

IC COMPLIANCE STATEMENT - CAN ICES-3 (A)/NMB-3 (A)
This device complies with the Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
1.  This device may not cause harmful interference, and

2.  This device must accept any interference received, including interference that may cause 

      undesired operation.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage, et
2.  L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est

     susceptible d’en compromettre le fonctionnement.

 

Previous Articles RF Modules
Next Articles Radio Transmitter